IN-DASH INSTALLATION KIT FOR
1988-03 FULL SIZE PICKUP/SPORT UTILITY
© 2007 SCOSCHE INDUSTRIES, INC.
If you have any further questions, call
LIABILITY DISCLAIMER
This instruction booklet is based on carefully documented data and research of automobile dash disassembly, wire
harness/codes and information pertaining to installation of this kit (GM1488) in 1988-03 General Motors Vehicles.
Scosche Industries, Inc. can not be held responsible for discrepancies/inconsistencies that may occur due to the
automobile manufacturing changes or options, or damage that may occur in the automobile during the installation of
components while using this booklet.
SI 12/06 - GM1488 (3000317)
TECH HELP 1-800-621-3695 x 3
GM1488
CADILLAC
1999-02 ESCALADE
2002-02 ESCALADE EXR
CHEVROLET
1996-02 ASTRO VAN
2001-02 AVALANCHE
1992-94 BLAZER FULL SIZE
1992-99 CREW CAB / DOOLEY PICKUP
1996-00 EXPRESS VAN
1988-02 PICKUP FULL SIZE
1992-02 SUBURBAN
1995-02 TAHOE
GMC
1992-00 CREW CAB / DOOLEY PICKUP
1988-02 PICKUP FULL SIZE
1996-03 SAFARI
1996-00 SAVANNA
1992-02 SUBURBAN
1992-02 YUKON
1999-99 YUKON DENALI
2000-02 YUKON XL
#2006
MOUNTING
PANEL
#2224R
MOUNTING
CLIP (RIGHT)
#2224L
MOUNTING CLIP
(LEFT)
#1869/2543
MOUNTING
PANEL
HEX NUT
CARRIAGE
BOLT
1996-02 Chevrolet Astro Van
1996-03 GMC Safari Van
RADIO REMOVAL:
1. Extract (2) T-30 torx bolts, one from each side of the top console area and pop out top half of center
console assembly.
2. Extract (2) 9/32" hex screws from the bottom edge of the driver’s side under dash panel and (1) screw
from left dash below defroster vent.
3. Carefully pry underdash panel out to release, and use caution when handling parking brake release cable.
4. Insert key into "on", adjust shifter down (low gear), Pull outward on the instrument/radio panel to release
clips. Unplug switches, and remove panel.
5. Push down on side tabs securing radio, slide out of dash, unplug, and remove radio.
4
1996-00 Chevrolet Express Van
1996-00 GMC Savanna
RADIO REMOVAL:
1. Carefully pull out on dash instrument/radio dash bezel to release spring clips, unplug connectors and
remove panel.
2. Compress the two plastic side radio mounting clips, slide radio out of dash, unplug connectors and remove
radio.
INTRODUCTION / PRELIMINARY
This premium installation kit is for 1988-03 Full Size Pickup/Sport Utility vehicles. Included are all the parts
you need to mount your car stereo/cassette or CD player into your vehicle's dash. Refer to the individual
instruction in this manual to remove your vehicle's factory radio and assemble the kit.
CAUTION:
DISCONNECT YOUR VEHICLE'S NEGATIVE BATTERY TERMINAL BEFORE THE INSTALLATION TO HELP
PREVENT ELECTRICAL DAMAGE. WE RECOMMEND THE USE OF A VOLT/OHM METER OVER A TEST LIGHT TO
CHECK WIRING. A TEST LIGHT OR GROUNDED WIRE PROBE CAN CAUSE DAMAGE TO THE VEHICLE'S
COMPUTER AND/OR DIAGNOSTIC SYSTEMS. AVOID ALL FACTORY AIRBAG WIRING - AIRBAGS CAN
ACCIDENTALLY DEPLOY CAUSING SERIOUS INJURY OR DEATH.
NOTES:
• See your vehicle's instructions for any special tools your installation might require.
• Read all instructions accompanying your car stereo/cassette player for proper wiring and mounting
instructions.
CAR STEREO CONNECTORS
PROVIDE EASY CONNECTION OF YOUR CAR
STEREO TO FACTORY WIRING HARNESS.
GM02B
1988-Up
FACTORY WIRING CODES
GM02B
MDA-1B
Antenna Adaptor
MDA-1B
Commentaires sur ces manuels